diplomat washer dryer instruction manual

Use for permanent press items and synthetics. Use for sturdy items like play or work clothes. Temperature is set based on the cycle selected.ĭR5: Set Cycle Selection to Auto-Sensing, the Fabric Selector to the desired cycle setting, and Auto-Dryness to the desired dryness level.ĭry heavy items such as blankets on this cycle. The time will vary with load size, type of fabric, amount of moisture in the load, air flow and the laundry room environment.ĭR7: Select the Auto-Sensing cycle and Dryness setting desired. When a wet load is put into the dryer it takes a certain amount of time to reach the desired dryness level. Auto-Sensing cycles are Energy Saver cycles that help prevent over-drying. The Auto-Sensing drying cycle operation is determined by the type of cycle selected as well as the moisture sensing system, which can be set by changing the Dryness setting. The cycle settings may be modified using the Selections and Options. The following cycle descriptions will help determine which cycle to choose depending on the type of laundry being dried. Start dryer and check that dryer is heating Cycle Information.Electric models – connect electrical cord with three-wire or four-wire plug.Retighten connections and recheck for leaks. If bubbles are present then a leak is likely. Turn on gas and check all pipe connections (internal and external) for gas leaks by applying a non-corrosive leak detection fluid to the fittings. Tighten all connections securely but do not overtighten to avoid breaking or bending the gas valve bracket.Refer to installation instructions, which can be found at Gas service to a gas dryer must conform with the local codes and ordinances. The free area of any opening for outside air must be at least 40 in2 (25806 mm2 ) per unit Sufficient make-up air must be supplied.Maximum straight duct length = 65 ft (19.8 m).Dryer must be exhausted to the outdoors.Wait 30 minutes and check again, some leaks are slow to show up Check that Y-connector valves are open (if applicable).Connect/Reconnect washer inlet hose to the other end of Y-connector.Connect the rubber washer end of inlet hose to the fill valve on rear of dryer.Connect filter screen end of the inlet hose to the Y-Connector.Insert filter screen on the faucet end of inlet hose with the screen facing the faucet and the rubber washer on the dryer end of the hose.Install Y-connector onto cold-water supply (use extension hose if Y connector cannot be installed directly on water supply).Insert rubber washer into Y-connector (both sold separately).Disconnect cold-water inlet hose from water supply if washing machine is connected.Steam models – connect water inlet hose, flushing lines.Recommended rear clearance minimum is 2 in (51 mm) for utility connections and 6 in (152 mm) when venting through rear of unit.One Filter Screen Washer (Steam Models).

Diplomat washer dryer instruction manual